Home › SUSPENSION & AXLE › SUSPENSION › TORSION BAR SPRING

TORSION BAR SPRING > INSPECTION

for Preparation Click here



1. INSPECT TORSION BAR SPRING


    C101962E02
  1. Use V blocks and a dial indicator to check the runout of the torsion bar spring.

    Maximum:
    2.0 mm (0.079 in.)

    NOTICE:
    Set the dial indicator perpendicular to the middle of the torsion bar spring.

    If the value is not within the specified range, replace the torsion bar spring with a new one.