Home › SUSPENSION & AXLE › SUSPENSION › FRONT SUSPENSION LOWER ARM

FRONT SUSPENSION LOWER ARM > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT SUSPENSION LOWER ARM


    C102013E02
  1. Temporarily install the suspension lower arm and washer to the vehicle with the nut.

  1. Align the matchmarks on the front suspension No.1 camber adjust cam, front suspension No.2 camber adjust cam and suspension member.

  1. Temporarily tighten the washer and nut.

    NOTICE:
    Align the matchmarks.



    C102012E01
  1. Install front suspension lower arm to the front lower ball joint with the 2 bolts and 2 nuts.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }



2. INSTALL FRONT STRUT BAR


    C102048E01
  1. Install the tube, strut bar cushion, strut bar retainer and washer to the strut bar and temporarily tighten the nut.

    NOTICE:
    Do not place the strut bar retainer and strut bar cushion in the wrong directions.



    C102011E01
  1. Install the strut bar to the front suspension lower arm with the 2 bolts and 2 nuts.

    Torque:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }



3. CONNECT FRONT SHOCK ABSORBER


    C102009E02
  1. Connect the front shock absorber to the front suspension lower arm with the bolt.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }



4. CONNECT FRONT STABILIZER LINK ASSEMBLY
  1. Install the 2 retainers and cushion.

  1. Connect the stabilizer bar link to the front suspension lower arm.

  1. Install the cushion retainer to the front suspension lower arm.



    C113869E01
  1. Install and tighten a new lock nut until the protrusion length of the thread is the standard length.

    Standard:
    5 +- 1 mm (0.20 +- 0.04 in.)



5. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }



6. STABILIZE SUSPENSION


7. FULLY TIGHTEN FRONT SUSPENSION LOWER ARM


    C102013E02
  1. Align the matchmarks on front suspension No.1 camber adjust cam and front suspension No.2 camber adjust cam and fully tighten the nut.

    Torque:
    170 N*m{ 1,730 kgf*cm , 125 ft.*lbf }



8. FULLY TIGHTEN FRONT STRUT BAR


    C102010E02
  1. Fully tighten the strut bar nut (rear side).

    Torque:
    138 N*m{ 1,410 kgf*cm , 102 ft.*lbf }



9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)