FRONT LOWER BALL JOINT > INSTALLATION |
| 1. INSTALL FRONT LOWER BALL JOINT |
Fix the steering knuckle in the vise using aluminum plates.
Install the front lower ball joint to the steering knuckle with the nut.
Install a new cotter pin to the front lower ball joint.
| 2. INSTALL FRONT AXLE ASSEMBLY |
Temporarily install the front axle assembly to the front suspension upper arm and front suspension lower arm.
![]() |
Fully tighten front suspension lower arm with the 4 bolts and 4 nuts.
![]() |
Fully tighten the front suspension upper arm with the nut.
Install a new cotter pin to the front suspension upper arm.
| 3. INSTALL TIE ROD END SUB-ASSEMBLY |
Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.
Install a new cotter pin.
| 4. INSTALL FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY |
| 5. CONNECT FRONT SPEED SENSOR |
![]() |
Connect the front speed sensor with the 2 bolts and 2 clips.
| 6. INSTALL FRONT WHEEL |
| 7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |