Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER BALL JOINT

FRONT LOWER BALL JOINT > INSPECTION

for Preparation Click here



1. INSPECT FRONT LOWER BALL JOINT


    C102060
  1. Flip the ball joint stud back and forth 5 time as shown in the illustration before installing the nut.

  1. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the 5th turn.

    Turning torque:
    6.5 N*m (66 kgf*cm, 58 in.*lbf) or less

    If the value is not within the specified range, replace the lower ball joint assembly with a new one.

  1. Check the dust boots for cracks or grease leakage.
    If the value is not within the specified range, replace the lower ball joint assembly with a new one.