FRONT LOWER BALL JOINT > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the 2 bolts and 2 clips to separate the front speed sensor.
| 3. SEPARATE FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, and disconnect the brake caliper assembly.
| 4. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and the nut.
![]() |
Using SST, separate the tie rod end sub-assembly LH from the steering knuckle.
| 5. REMOVE FRONT AXLE ASSEMBLY |
![]() |
Remove the 4 bolts, 4 nuts and front axle assembly from the front suspension lower arm.
Remove the cotter pin and castle nut.
![]() |
Using SST, remove the front axle assembly from the front suspension upper arm.
| 6. REMOVE FRONT LOWER BALL JOINT |
Fix the steering knuckle in the vise using aluminum plates.
Remove the cotter pin.
Loosen the nut.
![]() |
Use SST, separate the front lower ball joint from the steering knuckle.
Remove the nut and front lower ball joint.