Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO.1 STABILIZER BRACKET


  1. Install the front No.1 stabilizer bracket.



      C102066E02
    1. Temporarily tighten the bolt (A) until front No.1 stabilizer bracket sits in position.

    2. Install the 4 bolts (B) and then fully tighten the bolt (A).

      Torque:
      36 N*m{ 367 kgf*cm , 27 ft.*lbf }

      NOTICE:
      1. The stamped arrow must point toward the front of the vehicle.
      2. Tighten the 4 bolts (B) before fully tightening bolt (A).



2. INSTALL FRONT NO.1 STABILIZER BAR BUSHING


    C113895E01
  1. Install the 2 front No.1 stabilizer bar bushings to the outer side of the bushing stopper on the stabilizer bar.

    HINT:
    The protrusions on front No.1 stabilizer bar bush must be on the stopper side.



3. INSTALL FRONT STABILIZER BAR
  1. Install the front stabilizer bar to the vehicle.



4. INSTALL FRONT NO.2 STABILIZER BRACKET LH


    C102065E02
  1. Install the front No.2 stabilizer bracket LH with the 2 bolts.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Direct the stamped arrow toward the vehicle front.



5. INSTALL FRONT NO.2 STABILIZER BRACKET RH

HINT:
Use the same procedures for the LH side.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the 2 retainers and cushion.

  1. Connect the stabilizer bar link to the front suspension lower arm.

  1. Install the cushion and retainer to the front suspension lower arm.



    C113869E01
  1. Install and tighten a new lock nut until the protrusion length of the thread is the standard length.

    Standard:
    5 +- 1 mm (0.20 +- 0.04 in.)



    C102063E01
  1. Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

    HINT:
    If the stud bolt rotates with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.



7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures for the LH side.



8. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }



9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)