Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSPECTION

for Preparation Click here



1. INSPECT FRONT STABILIZER LINK ASSEMBLY


    C102067
  1. Flip the ball joint stud back and forth 5 time as shown in the illustration before installing the nut.

  1. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the 5th turn.

    Turning torque:
    1.96 N*m (20 kgf*cm, 17 in.*lbf) or less

    If the value is not within the specified range, replace the front stabilizer link assembly with a new one.

  1. Check the dust boots for cracks or grease leakage.
    If the value is not within the specified range, replace the front stabilizer link assembly with a new one.