Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO RECEIVER

RADIO RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.1


    B102820
  1. Using a moulding remover, disengage the 3 claws and remove the instrument cluster finish panel No.1 garnish.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER


  1. Using a roof moulding remover, disengage the claws in the order shown in the illustration.


    B102814E01



    B102815E01
  1. Attach tape to the positions shown in the illustration in order to prevent the instrument cluster finish panel sub-assembly center from being damaged.

  1. Using a moulding remover, disengage the claw.



    B102816
  1. Hold the panel as shown in the illustration and pull it toward the rear of the vehicle to disengage the claws.



    B102817
  1. While supporting the panel with your right hand, pull it toward the rear of the vehicle to disengage the claws.



    B102818
  1. Hold the panel as shown in the illustration and disengage the claws.



    B102819
  1. Hold the panel as shown in the illustration and pull it toward the rear of the vehicle to disengage the claws. Remove the instrument cluster finish panel sub-assembly center.



3. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    E103058
  1. Remove the 4 screws.

  1. Disconnect the connectors and the radio receiver assembly with bracket.



4. REMOVE RADIO RECEIVER PANEL (1DIN TYPE)


    E111880
  1. Remove the 2 screws and the radio receiver panel.



5. REMOVE RADIO RECEIVER PANEL (1DIN TYPE)


    E111881
  1. Remove the 2 screws and the radio receiver panel.



6. REMOVE RADIO BRACKET NO.1
  1. 1DIN TYPE:

    1. Remove the 4 screws and the radio bracket No.1.

  1. 1.4DIN TYPE:

    1. Remove the 3 screws and the radio bracket No.1.



  1. 2DIN TYPE:



    1. Remove the 4 screws and the radio bracket No.1.


      E111883E01



7. REMOVE RADIO BRACKET NO.2
  1. 1DIN TYPE:

    1. Remove the 4 screws and the radio bracket No.2.

  1. 1.4DIN TYPE:

    1. Remove the 3 screws and the radio bracket No.2.



  1. 2DIN TYPE:



    1. Remove the 4 screws and the radio bracket No.2.


      E111882E01