Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT NO. 1 SPEAKER

FRONT NO. 1 SPEAKER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO.1 SPEAKER ASSEMBLY


    E106943E01
  1. Using an air riveter or hand riveter, install 3 new strike rivets on the front No.1 speaker assembly on the front door panel.

    HINT:
    Install the new strike rivets in order as shown in the illustration.

    NOTICE:

    1. H002440
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. H002441
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet to the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. H002442
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

  1. Connect the connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B102849E01
  1. Engage the 12 clips and install the front door trim board sub-assembly with the screw.



3. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (Without Power Window)
  1. Temporarily install the front door window regulator handle assembly, and completely close the front door glass.



    B102871E01
  1. Install the front door window regulator handle as shown in the illustration.