FRONT NO. 1 SPEAKER > REMOVAL |
| 1. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (Without Power Window) |
![]() |
Remove the front door window regulator handle shaft snap ring and the front door window regulator handle assembly.
| 2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Remove the screw.
Using a clip remover, disengage the 12 clips and remove the front door trim board sub-assembly.
| 3. REMOVE FRONT NO.1 SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No.1 speaker assembly from the front door panel.
Operate the drill along the rivet head circumference and cut out the flange.
After drilling out the flange, continue drilling to push out the shards on the drill.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.