FRONT SIDE WINDOW GLASS > REMOVAL |
| 1. REMOVE SLIDE DOOR WINDOW GARNISH LH |
![]() |
Disengage the 4 clips and remove the slide door window garnish.
| 2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Using a "torx" socket wrench (T25), remove the 2 "torx" screws.
![]() |
Disengage the 19 clips and claw and remove the rear door trim board sub-assembly.
| 3. REMOVE REAR DOOR TRIM MOULDING NO.2 LH |
Remove the rear door trim moulding No.2 LH as shown in the illustration.

| 4. REMOVE FRONT SIDE WINDOW GLASS |
![]() |
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
From the interior, insert piano wires between the vehicle body and back door glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
Cut through the adhesive by pulling the piano wire around the back door glass.
Using a suction cup, remove the back door glass.