Home › BODY › WINDSHIELD / WINDOWGLASS › REAR SIDE WINDOW GLASS

REAR SIDE WINDOW GLASS > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR SCUFF PLATE


    B106176E01
  1. Using a screwdriver, disengage the 7 clips and 4 claws and remove the back door scuff plate.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE BACK DOOR WEATHERSTRIP


3. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    B103256
  1. Remove the bolt and disconnect the front seat outer belt assembly LH.



    B103245E01
  1. Using a screwdriver, disengage the 2 claws and cover.

    HINT:
    Tape the screwdriver tip before use.



    B103246
  1. Remove the bolt and disconnect the front seat outer belt assembly LH.



4. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR LH


    B113348
  1. Using a screwdriver, disengage the 35 clips and remove the quarter trim panel assembly rear LH.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE QUARTER PILLAR GARNISH LH


    B106184E02
  1. Release the 6 clips and remove the quarter pillar garnish LH.



6. REMOVE ROOF SIDE GARNISH INNER UPPER LH


    B113352
  1. Using a screwdriver, disengage the 6 clips and remove the roof side garnish inner upper LH.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE REAR SIDE WINDOW GLASS


    B115250
  1. Apply protective tape to the outer surface of the vehicle body to prevent scratches.

  1. From the interior, insert piano wires between the vehicle body and back door glass as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the back door glass from the vehicle, be careful not to damage the vehicles paint or interior/exterior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the back door glass.

  1. Using a suction cup, remove the back door glass.

    NOTICE:
    Leave as much adhesive on the vehicle body as possible when removing the back door glass.