Home › BODY › WINDSHIELD / WINDOWGLASS › BACK DOOR GLASS

BACK DOOR GLASS > REMOVAL

for Preparation Click here



1. REMOVE REAR WIPER ARM


    E103137E01
  1. Disengage the 3 claws and separate the head cap as shown in the illustration.

  1. Remove the rear wiper arm nut and rear wiper arm and blade assembly.



2. REMOVE REAR WIPER SHAFT COVER


    E103139
  1. Remove the rear wiper shaft cover.



3. REMOVE REAR WIPER LINK PIVOT WASHER NO.1


    E103140
  1. Using the socket wrench (27 mm), remove the lock nut and rear No.1 wiper link pivot washer.

    NOTICE:
    Do not damage the glass.



4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY UPPER


    B101147E01
  1. Disengage the 6 clips and remove the back door trim board assembly upper.

  1. Remove the remaining clips on the body, and reinstall them to the back door trim board assembly upper.



5. REMOVE REAR WIPER MOTOR ASSEMBLY


    E103138E01
  1. Disconnect the connector and remove the clamp.

  1. Remove the 3 bolts and rear wiper motor and grommet as a unit.



    E104706E01
  1. Remove the grommet from the rear wiper motor.



6. REMOVE BACK DOOR GLASS


    B115415E01
  1. Apply protective tape to the outer surface of the vehicle body to prevent scratches.



    B101851
  1. From the interior, insert piano wires between the vehicle body and back door glass as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the back door glass from the vehicle, be careful not to damage the vehicles paint or interior/exterior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the back door glass.

  1. Using a suction cup, remove the back door glass.

    NOTICE:
    Leave as much adhesive on the vehicle body as possible when removing the back door glass.