Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH (RHD)


    E011948
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Light control switch:
    Tester connection
    Switch operation
    Specified condition
    9 - 13
    9 - 14
    9 - 15
    OFF
    10 kΩ or higher
    9 - 15
    TAIL
    Below 1 Ω
    9 - 14
    9 - 15
    HEAD
    Below 1 Ω
    9 - 13
    AUTO
    Below 1 Ω
    Headlight dimmer switch:
    Tester connection
    Switch operation
    Specified condition
    1 - 9
    2 - 9
    FLASH
    Below 1 Ω
    9 - 10
    LOW BEAM
    Below 1 Ω
    2 - 9
    HIGH BEAM
    Below 1 Ω
    Turn signal switch:
    Tester connection
    Switch operation
    Specified condition
    7 - 8
    Right turn
    Below 1 Ω
    6 - 7
    7 - 8
    Neutral
    10 kΩ or higher
    6 - 7
    Left turn
    Below 1 Ω
    Fog light switch:
    Tester connection
    Switch operation
    Specified condition
    12 - 16
    OFF
    10 kΩ or higher
    12 - 16
    ON
    Below 1 Ω

    If the result is not as specified, replace the headlight dimmer switch.



2. INSPECT HEADLIGHT DIMMER SWITCH (LHD)


    E011948
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Light control switch:
    Tester connection
    Switch operation
    Specified condition
    16 - 13
    16 - 14
    OFF
    10 kΩ or higher
    16 - 14
    TAIL
    Below 1 Ω
    16 - 13
    16 - 14
    HEAD
    Below 1 Ω
    Headlight dimmer switch:
    Tester connection
    Switch operation
    Specified condition
    7 - 16
    8 - 16
    FLASH
    Below 1 Ω
    16 - 17
    LOW BEAM
    Below 1 Ω
    7 - 16
    HIGH BEAM
    Below 1 Ω
    Turn signal switch:
    Tester connection
    Switch operation
    Specified condition
    2 - 3
    Right turn
    Below 1 Ω
    1 - 2
    2 - 3
    Neutral
    10 kΩ or higher
    1 - 2
    Left turn
    Below 1 Ω
    Fog light switch:
    Tester connection
    Switch operation
    Specified condition
    10 - 11
    OFF
    10 k Ω or higher
    10 - 11
    ON
    Below 1 Ω

    If the result is not as specified, replace the headlight dimmer switch.