HEADLIGHT ASSEMBLY > ADJUSTMENT |
| 1. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT |
Prepare the vehicle:
| 2. PREPARATION FOR HEADLIGHT AIMING (Using a screen) |
![]() |
Prepare the vehicle according to the following conditions:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
H Line (Headlight height):
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) headlights):
| 3. HEADLIGHT AIMING INSPECTION |
Cover or disconnect the connector of the headlight on the opposite side to prevent light from the headlight not being inspected from affecting headlight aiming inspection.
Start the engine.
With headlight leveling switch:
Set the headlight leveling switch to 0 (zero).
Turn on the headlight and make sure that the cutoff line falls within the specified area, as shown in the illustration.

| 4. HEADLIGHT AIMING ADJUSTMENT |
![]() |
Adjust the aim vertically:
Adjust the aim horizontally: