FOG LIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL FOG LIGHT BRACKET |
![]() |
Install the fog light bracket with the 2 claws and the 2 pins.
| 2. INSTALL FOG LIGHT ASSEMBLY WITH BRACKET |
![]() |
Install the fog light assembly with bracket with the 2 bolts and the clip.
| 3. INSTALL FOG LIGHT COVER |
![]() |
Install the fog light cover with the 3 claws.
| 4. INSTALL FRONT BUMPER ASSEMBLY |
| 5. INSTALL STEP PLATE COVER LH |
| 6. INSTALL STEP PLATE COVER RH |
| 7. INSTALL RADIATOR GRILLE |
| 8. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT |
Prepare the vehicle:
| 9. PREPARATION FOR FOG LIGHT AIMING |
![]() |
Prepare the vehicle according to the following conditions:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
H Line (Fog light height):
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
| 10. FOG LIGHT AIMING INSPECTION |
Cover or disconnect the connector of the fog light on the opposite side to prevent light from the fog light not being inspected from affecting fog light aiming inspection.
Start the engine.
Turn on the fog light and make sure that the cutoff line falls within the specified area, as shown in the illustration.

| 11. FOG LIGHT AIMING ADJUSTMENT |
![]() |
Adjust the fog light aim into the specified range by turning the aiming screw with a screwdriver.