LICENSE PLATE LIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL LICENSE PLATE LIGHT ASSEMBLY |
Install the license plate light assembly with the 2 screws and the 2 clamps.
| 2. INSTALL BACK DOOR OUTSIDE GARNISH |
![]() |
Install the grommet and back door outside garnish.
![]() |
Install the 2 clips.
Install the back door outside garnish with the 5 nuts.
Connect the connector.
| 3. INSTALL BACK DOOR TRIM BOARD (GL Grade) |
![]() |
Install the back door trim board with the 16 clips.
| 4. INSTALL BACK DOOR TRIM BOARD (DX Grade) |
![]() |
Engage the 18 clips and install the back door trim board.
| 5. INSTALL BACK DOOR INSIDE HANDLE BEZEL (w/ Back Door Inside Handle Bezel) |
![]() |
Install the back door inside handle bezel with the 2 screws.
| 6. INSTALL BACK DOOR INSIDE HANDLE (w/ Back Door Inside Handle) |
![]() |
Install the back door inside handle with the screw.