Home › BODY ELECTRICAL › LIGHTING › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR INSIDE HANDLE (w/ Back Door Inside Handle)


    B101148
  1. Remove the screw and the back door inside handle.



2. REMOVE BACK DOOR INSIDE HANDLE BEZEL (w/ Back Door Inside Handle Bezel)


    B101149
  1. Remove the 2 screws and the back door inside handle bezel.



3. REMOVE BACK DOOR TRIM BOARD (DX Grade)


    B101151
  1. Using a clip remover, remove the 16 clips and the back door trim board.



4. REMOVE BACK DOOR TRIM BOARD (GL Grade)


    B101152E01
  1. Using a clip remover, remove the 18 clips and the back door trim board.



5. REMOVE BACK DOOR OUTSIDE GARNISH
  1. Disconnect the connector.

  1. Remove the 5 nuts.



    E109050E01
  1. Release the 2 clips and back door garnish outside.



    B103905
  1. Remove the grommet and back door garnish outside.



6. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E103127E01
  1. Remove the 2 screws and the 2 clamps.

  1. Remove the license plate light assembly as shown in the illustration.