Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT WIPER MOTOR


    E108765
  1. Using a "torx" socket wrench (T30), install the front wiper motor with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



    E061919
  1. Apply MP grease to the crank arm pivot of the front wiper motor.

  1. Install the rod to the front wiper motor as shown in the illustration.



2. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    E108766
  1. Engage the grommet as shown in the illustration.

  1. Install the windshield wiper motor and link assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector.



3. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E108767E01
  1. Body type narrow:

    1. Install the cowl top ventilator louver sub-assembly with the 10 claws and 6 clips.

  1. Body type wide:

    1. Install the cowl top ventilator louver sub-assembly with the 11 claws and 7clips.

  1. Connect the washer hose.



4. INSTALL COWL VENT COVER LH


5. INSTALL COWL VENT COVER RH


6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH


    B108016E03
  1. Operate the wiper, and stop the windshield wiper motor assembly at the automatic stop position.

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).



    E108758E01
  1. Install the front wiper arm and blade assembly LH with the nut at the position as shown in the illustration.

    Torque:
    25 N*m{ 225 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.



7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH


    B108016E03
  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).



    E108757E01
  1. Install the front wiper arm and blade assembly RH with the nut at the position as shown in the illustration.

    Torque:
    25 N*m{ 225 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.



8. INSTALL WINDSHIELD WIPER ARM COVER
  1. Install the 2 windshield wiper arm covers.

  1. Operate the front wipers while spraying water or washer fluid on the windshield. Make sure that the wipers function properly and there is no interference with the vehicle body.