Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER ARM COVER
  1. Remove the 2 windshield wiper arm covers.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
  1. Remove the nut and front wiper arm and blade assembly RH.



3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
  1. Remove the nut and front wiper arm and blade assembly LH.



4. REMOVE COWL VENT COVER RH


    E108759
  1. Disengage the 2 claws and remove the cowl vent cover RH as shown in the illustration.



5. REMOVE COWL VENT COVER LH


    E108760
  1. Disengage the 2 claws and remove the cowl vent cover LH as shown in the illustration.



6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E108761E01
  1. Disconnect the washer hose at position <a> shown in the illustration.

  1. Body type narrow:

    1. Disengage the 10 claws, and remove the 6 clips and cowl top ventilator louver sub-assembly.

  1. Body type wide:

    1. Disengage the 11 claws, and remove the 7 clips and cowl top ventilator louver sub-assembly.



7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    E108762E01
  1. Disconnect the connector.

  1. Remove the 2 bolts.

  1. Disengage the grommet and remove the windshield wiper motor and link assembly as shown in the illustration.



8. REMOVE FRONT WIPER MOTOR


    E108763E01
  1. Using a screwdriver wrapped with protective tape, separate the upper rod of the wiper link assembly from the front wiper motor as shown in the illustration.



    E108764E01
  1. Using a screwdriver wrapped with protective tape, separate the lower rod of the wiper link assembly from the front wiper motor as shown in the illustration.



    E108765
  1. Using a "torx" socket wrench (T30), remove the 2 bolts and front wiper motor.