Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR


    E104706E01
  1. Install the grommet as shown in the illustration.



    E103138E01
  1. Install the rear wiper motor with the 3 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Install the clamp and connect the connector.



2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY UPPER


    B101147E01
  1. Engage the clips and install the back door trim board assembly upper.



3. INSTALL REAR NO.1 WIPER LINK PIVOT WASHER


    E103141E02
  1. Install the rear No.1 wiper link pivot washer from the outside of the vehicle with the installation mark at the top.



    E103140
  1. Using the socket wrench (27 mm), install the lock nut.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }

    NOTICE:
    Do not damage the glass.



4. INSTALL REAR WIPER SHAFT COVER


5. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    B108016E03
  1. Operate the wiper, and stop the rear wiper motor at the automatic stop position.

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).



    E103534E01
  1. Install the rear wiper arm and blade assembly with the nut at the position as shown in the illustration.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.

  1. Operate the rear wiper while spraying water or washer fluid on the windshield. Make sure that the wipers function properly and there is no interference with the vehicle body.