Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


    E103137E01
  1. Disengage the 3 claws and separate the head cap as shown in the illustration.

  1. Remove the rear wiper arm nut and rear wiper arm and blade assembly.



2. REMOVE REAR WIPER SHAFT COVER


    E103139
  1. Remove the rear wiper shaft cover.



3. REMOVE REAR NO.1 WIPER LINK PIVOT WASHER


    E103140
  1. Using the socket wrench (27 mm), remove the lock nut and rear No.1 wiper link pivot washer.

    NOTICE:
    Do not damage the glass.



4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY UPPER


    B101147E01
  1. Disengage the 6 clips and remove the back door trim board assembly upper.

  1. Remove the remaining clips on the body, and reinstall them to the back door trim board assembly upper.



5. REMOVE REAR WIPER MOTOR


    E103138E01
  1. Disconnect the connector and remove the clamp.

  1. Remove the 3 bolts and rear wiper motor and grommet as a unit.



    E104706E01
  1. Remove the grommet from the rear wiper motor.