Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Split Bench Seat Type)

FRONT SEAT ASSEMBLY (for Split Bench Seat Type) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEATBACK CENTER ASSEMBLY


    B101697E01
  1. Install the front seatback center assembly with the 4 bolts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    1. Tighten the bolts in the following order:
    2. Temporarily tighten bolt (1).
    3. Fully tighten bolt (2).
    4. Fully tighten bolt (1).
    5. Fully tighten bolt (3).
    6. Fully tighten bolt (4).



2. INSTALL FRONT SEATBACK ASSEMBLY


    B101688E01
  1. Install the front seatback assembly with the 4 bolts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.



3. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


    B101687E01
  1. w/o Seat belt warning occupant detection sensor:

    1. Install the separate type front seat cushion cover with pad with the 2 bolts.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

      NOTICE:
      1. Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
      2. Tighten the bolts in the following order.
      3. Temporarily tighten bolt (2).
      4. Fully tighten bolt (1).
      5. Fully tighten bolt (2).



    B103882E01
  1. w/ Seat belt warning occupant detection sensor:

    1. Connect the connector.

    2. Install the separate type front seat cushion cover with pad with the 2 bolts.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

      NOTICE:
      1. Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
      2. Tighten the bolts in the following order.
      3. Temporarily tighten bolt (2).
      4. Fully tighten bolt (1).
      5. Fully tighten bolt (2).