Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Split Bench Seat Type)

FRONT SEAT ASSEMBLY (for Split Bench Seat Type) > REASSEMBLY

for Preparation Click here



1. INSTALL CENTER SEATBACK PAD


2. INSTALL FRONT SEATBACK COVER CENTER


3. INSTALL RECLINING SEATBACK ADJUSTER ASSEMBLY


    B101707
  1. Using a "torx" socket T50, install the reclining seatback adjuster assembly with the 2 "torx" bolts.

    Torque:
    41 N*m{ 418 kgf*cm , 30 ft.*lbf }



    B113596E01
  1. Using hog ring pliers, install the front seatback cover center to the center seatback pad with 8 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



4. INSTALL FRONT SEAT CUSHION COVER SET PLATE


    B115235
  1. Install the front seat cushion cover set plate with the bolt and bush.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }



5. INSTALL CENTER SEAT HINGE COVER UPPER


6. INSTALL CENTER SEAT HINGE COVER RH


7. INSTALL CENTER SEAT HINGE COVER LH


8. INSTALL RECLINING ADJUSTER RELEASE HANDLE


9. INSTALL CONSOLE BOX ASSMBLY


10. INSTALL REAR SEAT CENTER ARMREST SUPPORT


11. INSTALL FRONT SEAT SIDE TABLE


12. INSTALL FRONT SEATBACK CONTROL PANEL HOLE COVER


13. INSTALL FRONT SEATBACK FRAME SUB-ASSMBLY


14. INSTALL SEAT FRONT SEAT LEG COVER


15. INSTALL RECLINING ADJUSTER INSIDE COVER RH


16. INSTALL RECLINING ADJUSTER INSIDE COVER LH


17. INSTALL FRONT SEAT CUSHION SHIELD INNER


18. INSTALL FRONT SEAT CUSHION SHIELD INNER NO.1


19. INSTALL RECLINING ADJUSTER RELEASE HANDLE


20. INSTALL SEPARATE TYPE FRONT SEATBACK PAD


21. INSTALL SEPARATE TYPE FRONT SEATBACK COVER


    B113597E01
  1. Using hog ring pliers, install the separate type front seatback cover to the separate type front seatback pad with 5 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



    B113598E01
  1. Using hog ring pliers, install the 3 new hog rings.

    NOTICE:
    Be careful not to damage the cover.



22. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD


23. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER


    B113599E01
  1. Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 9 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



    B113600E01
  1. Using hog ring pliers, install the 23 new hog rings.

    NOTICE:
    Be careful not to damage the cover.