SFI SYSTEM (w/ Secondary Air Injection System) > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
DTCs which are stored in the ECM can be displayed with the intelligent tester and generic OBD scan tool.
These scan tools can display pending DTCs and current DTCs.
Some DTCs aren't stored if the ECM doesn't detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as a pending DTC.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester ON.
Enter the following menus: Powertrain/Engine and ECT/DTC.
Check and make a note of DTCs and freeze frame data.
Refer to the DIAGNOSTIC TROUBLE CODE CHART to confirm the details of the DTCs (Click here).
Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process again. When the problem has been simulated twice, the MIL illuminates and the DTCs are recorded in the ECM.
| CLEAR DTCS AND FREEZE FRAME DATA (using an intelligent tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position (do not start the engine) and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.
Erase DTCs and freeze frame data by pressing YES on the tester.
Turn the ignition switch off and then turn it on again, and check that no DTCs are displayed on the monitor.
If any DTCs are displayed, repeat from step (c).
| CLEAR DTCS AND FREEZE FRAME DATA (without using an intelligent tester) |
Perform either of the following operations:
Disconnect the battery negative (-) cable for more than 1 minutes.
Remove the EFI fuses from the engine room R/B for 1 minute or more.
However, if you disconnect the battery terminal, perform the "INITIALIZE" procedure (Click here).