Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

SFI SYSTEM (w/ Secondary Air Injection System) > FAIL-SAFE CHART

for Preparation Click here


If any of the following DTCs are recorded, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC No.
Fail-Safe Operation
Fail-Safe Deactivation Condition
P0031
P0032
Air fuel ratio sensor (Sensor 1) heater is turned off
Ignition switch turned to OFF
P0037
P0038
Heater oxygen sensor (Sensor 2) heater is turned off
Ignition switch turned to OFF
P0100
P0102
P0103
Ignition timing is calculated from engine RPM and Throttle Position (TP)
"Pass" condition detected
P0100
P0112
P0113
Intake Air Temperature (IAT) is fixed at 20°C (68°F)
"Pass" condition detected
P0115
P0117
P0118
Engine Coolant Temperature (ECT) is fixed at 80°C (176°F)
"Pass" condition detected
P0120
P0122
P0123
P0220
P0222
P0223
P2102
P2103
P2111
P2112
P2118
P2119
P2135
When Electronic Throttle Control System (ECTS) is malfunctioning, electric current to throttle actuator is cut off and throttle valve returns to Throttle Position (TP) 16° by its spring.
Then, required engine power is calculated using ignition timing and Accelerator Pedal Position (APP). Engine is controlled by intermittent fuel-cut.
As a result, fully depressing accelerator pedal slowly enables to drive at minimum speed. However, depressing pedal quickly would vary vehicle speed remarkably.
"Pass" condition detected followed by ignition switch being turned to OFF
P0121
Fuel is cut intermittently
"Pass" condition detected followed by ignition switch being turned to OFF
P0327
P0328
Maximum ignition timing retardation
Ignition switch turned to OFF
P0351
P0352
P0353
P0354
Fuel is cut
"Pass" condition detected
P2120
P2121
P2122
P2123
P2125
P2127
P2128
P2138
Accelerator Pedal Position (APP) sensor has the main circuit and associate circuit. When one of the circuits is malfunctioning, APP is calculated by output of other circuit. When both of circuits are malfunctioning, it is interpreted that accelerator pedal is being released. As a result, throttle valve is closed and engine idles.
"Pass" condition detected followed by ignition switch being turned to OFF.