Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

SFI SYSTEM (w/ Secondary Air Injection System) > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here


HINT:
Inspect the vehicle's ECM using check mode. Intermittent problems are easier to detect when the intelligent tester is in check mode. In check mode, the intelligent tester uses 1 trip detection logic, which has a higher sensitivity to malfunctions than normal mode (default), which uses 2 trip detection logic.


CHECK INTERMITTENT PROBLEMS
  1. Clear the DTCs.

  2. Set the check mode.

  3. Perform a simulation test. (Click here)

  4. Check the connector and terminal. (Click here)

  5. Handle the connector. (Click here)