Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.2 GARNISH


    B102813
  1. Using a moulding remover, disengage the 3 claws and remove the instrument cluster finish panel No.2 garnish.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER


  1. Using a roof moulding remover, disengage the claws in the order shown in the illustration.


    B102814E01



    B102815E01
  1. Attach tape to the positions shown in the illustration in order to prevent the instrument cluster finish panel sub-assembly center from being damaged.

  1. Using a moulding remover, disengage the claw.



    B102816
  1. Hold the panel as shown in the illustration and pull it toward the rear of the vehicle to disengage the claws.



    B102817
  1. While supporting the panel with your right hand, pull it toward the rear of the vehicle to disengage the claws.



    B102818
  1. Hold the panel as shown in the illustration and disengage the claws.



    B102819
  1. Hold the panel as shown in the illustration and pull it toward the rear of the vehicle to disengage the claws. Remove the instrument cluster finish panel sub-assembly center.



3. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1 GARNISH


    B102820
  1. Using a moulding remover, disengage the 3 claws and remove the instrument cluster finish panel No.1 garnish.



4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B102821
  1. Using a moulding remover, disengage the 4 claws and remove the instrument cluster finish panel assembly.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B102822
  1. Disengage the 6 claws and remove the instrument cluster finish panel sub-assembly.



6. REMOVE COMBINATION METER ASSEMBLY


    B102823
  1. Remove the 2 screws.



    B102824E01
  1. Disengage the 2 claws.

  1. Disconnect the connector and remove the combination meter assembly.