Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    12    Engine Speed Sensor Circuit Malfunction (TDC OR G1 Circuit)

for Preparation Click here


DESCRIPTION

The crankshaft position sensor in the Engine Control System contains a signal plate and a pickup coil for TDC signal. The TDC signal plate has 1 tooth on its outer circumference. The TDC signal sensor generates 1 signal for every engine revolution. The ECM detects the top dead center by the TDC signals.

DTC No.
DTC Detection Condition
Trouble Area
12
No DTC signal to ECM at 400 rpm or more
  1. Open or short in crankshaft position sensor circuit
  2. Crankshaft position sensor
  3. ECM

WIRING DIAGRAM


A110553E01


INSPECTION PROCEDURE

1.INSPECT CRANKSHAFT POSITION SENSOR


    A105091E01
  1. Check the crankshaft position sensor installation.

  1. Disconnect the crankshaft position sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    19 to 32 Ω (Cold)
    1 - 2
    24 to 37 Ω (Hot)

    HINT:
    "Cold" and "Hot" in the following sentence express the temperature of the sensor itself. "Cold" is from -10°C (14°F) to 50°C (122°F) and "Hot" is from 50°C (122°F) to 100°C (212°F).



NG
REPLACE CRANKSHAFT POSITION SENSOR
OK


2.INSPECT ECM


    A106823E01
  1. Connect the crankshaft position sensor connector.

  1. While cranking or idling, measure the waveform according to the value(s) in the table below.

    OK:
    Tester Connection
    Specified Condition
    TDC+ (D2-17) - TDC- (D2-16)
    Correct waveform shown
    NE+ (D2-19) - NE- (D2-18)
    Correct waveform shown



NG
Go to step 3
OK

REPLACE ECM 

3.CHECK HARNESS AND CONNECTOR (ECM - CRANKSHAFT POSITION SENSOR)


    A106824E01
  1. Disconnect the crankshaft position sensor connector.

  1. Disconnect the ECM D2 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    + (D62-1) - TDC+ (D2-17)
    Below 1 Ω
    - (D62-2) - TDC- (D2-16)
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    TDC+ (D2-17) - TDC- (D2-16)
    10 kΩ or higher
    TDC+ (D2-17) - Body ground
    10 kΩ or higher
    TDC- (D2-16) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

CHECK FOR INTERMITTENT PROBLEMS