Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    42    Vehicle Speed Sensor Signal Circuit Malfunction

for Preparation Click here


DESCRIPTION

The speed sensor for skid control ECU detects the wheel speed and sends the appropriate signals to the skid control ECU.
The ECM converts these signals into a 4-pulse signal and outputs it to the combination meter.
After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the ECM. The ECM determines the vehicle speed based on the frequency of these pulse signals.

A073544E01


DTC No.
DTC Detection Condition
Trouble Area
42
All conditions below are detected continuously for 8 sec. or more:
  1. Vehicle speed signal: 0 km/h (0 mph)
  2. Engine speed: 2,000 - 3,300 rpm
  3. Engine coolant temp.: 70°C (158°F) or more
  4. Accelerator pedal opening angle : 60 % or more
  1. Open or short in vehicle speed sensor circuit
  2. Vehicle speed sensor
  3. Combination meter
  4. ECM

WIRING DIAGRAM


A106784E01


INSPECTION PROCEDURE

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.

    OK:
    The speedometer operates normally according to vehicle speed.

    HINT:
    The vehicle speed sensor is operating normally if the speedometer display is normal.



NG
CHECK SPEEDOMETER CIRCUIT
OK


2.INSPECT ECM (CHECK VOLTAGE)


    A110539E01
  1. Shift the shift lever to the neutral position.

  1. Jack up the vehicle.

  1. Turn the ignition switch ON.

  1. Measure the voltage between the terminals SPD and E1 of the ECM connector when the wheel is turned slowly.

    OK:
    Tester Connection
    Specified Condition
    SPD (B10-9) - E1 (D2-14)
    Correct waveform shown



NG
Go to step 3
OK

REPLACE ECM 

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)


    A106812E01
  1. Disconnect the combination meter connector.

  1. Disconnect the ECM B10 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    +S (H20-9) - SPD (B10-9)
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    SPD (B10-9) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM