ECD SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
![]() |
Make sure that the vehicle is in the following condition:
Battery voltage is 11 V or more.
The shift lever is in the neutral position.
A/C is switched off.
Turn the ignition switch off (where on).
Connect the intelligent tester to the DLC3.
Turn the ignition switch on and turn the tester on.
Select the following menu items: Powertrain/Engine and ECT/Check Mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine (the MIL should turn off).
Simulate the conditions of the malfunction described by the customer.
Check the DTC(s) and freeze frame data using the tester.
After checking the DTC, inspect the applicable circuits (Click here).