DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
DTC P0341 Camshaft Position Sensor "A" Circuit Range / Performance (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0340 |
|
|
| P0341 | When crankshaft rotates twice, Camshaft Position (CMP) sensor signal input to ECM 12 times or more (1 trip detection logic) |
|

| Items | Contents |
| Terminals | CH1: G2 - NE- CH2: NE+ - NE- |
| Equipment Settings | 5 V/Division, 20 ms/Division |
| Conditions | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the D10 Camshaft Position (CMP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connections | Specified Conditions |
| 1 - 2 | 835 to 1,400 Ω at cold |
| 1 - 2 | 1,060 to 1,645 Ω at hot |
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the D10 CMP sensor connector.
Disconnect the D1 ECM connector.
Measure the resistance.
| Tester Connections | Specified Conditions |
| G+ (D10-1) - G2 (D1-26) | Below 1 Ω |
| G- (D10-2) - NE- (D1-34) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| G+ (D10-1) or G2 (D1-26) - Body ground | 10 kΩ or higher |
| G- (D10-2) or NE- (D1-34) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the CMP sensor installation condition.
|
| ||||
| OK | |
| 4.CHECK CAMSHAFT TIMING GEAR ASSEMBLY (TEETH OF SENSOR PLATE) |
Check the teeth of the sensor plate.
|
| ||||
| OK | ||
| ||