DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2102 |
|
|
| P2103 |
|
|

| 1.INSPECT THROTTLE W/MOTOR BODY ASSEMBLY (THROTTLE ACTUATOR RESISTANCE) |
![]() |
Disconnect the D29 throttle body connector.
Measure the resistance between the terminals of the throttle body.
| Tester Connections | Specified Conditions |
| M+ (2) - M- (1) | 0.3 to 100 Ω at 20°C (68°F) |
Reconnect the throttle body connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE ACTUATOR - ECM) |
![]() |
Disconnect the D29 throttle body connector.
Disconnect the D1 ECM connector.
Measure the resistance.
| Tester Connections | Specified Conditions |
| M+ (D29-2) - M+ (D1-5) | Below 1 Ω |
| M- (D29-1) - M- (D1-4) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| M+ (D29-2) or M+ (D1-5) - Body ground | 10 kΩ or higher |
| M- (D29-1) or M- (D1-4) - Body ground | 10 kΩ or higher |
Reconnect the throttle body connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE W/MOTOR BODY ASSEMBLY |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||