Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT PRESSURE SENSOR
  1. Install the manifold gauge set.

  1. Start the engine.

  1. Operate the air conditioning system.

  1. Disconnect the pressure sensor connector.

  1. Connect the positive (+) lead from three 1.5 V dry cell batteries to terminal 3 and negative (-) lead to terminal 1.



    E113142E01
  1. Check the voltage between terminals 2 and 1 of the pressure sensor.

    Standard voltage:
    The voltage varies with the refrigerant pressure as shown in the chart.

    If the voltage value is not as specified, replace the pressure sensor.