Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PRECAUTION

for Preparation Click here



1.WIRE HARNESS REPAIR


    F045104
  1. After repairing the wire bus line with a solder, wrap the repaired part with vinyl tape.

    NOTICE:
    1. The CANL bus line and CANH bus line must be installed together at all times.
      When installing, make sure to braid them.
    2. The difference in length between the CANL bus line and CANH bus line should be within 100 mm (3.93 in.).
    3. Leave approximately 80 mm (3.15 in.) loose in the braided wires around the connector.



  2. F045105E04
  3. Do not use a bypass wire between the connectors.

    NOTICE:
    If you use a bypass wire, the characteristic of the braided wire harness will be lost.


2.CONNECTOR HANDLING


    F045106
  1. When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.



  2. F045107E03
  3. If it is impossible to check resistance from the back of the connector, use a repair wire to check it.