Home › BODY › ENGINE HOOD / DOOR › SLIDE DOOR CLOSER RELAY

SLIDE DOOR CLOSER RELAY > REMOVAL

for Preparation Click here



1. REMOVE SLIDE DOOR WINDOW GARNISH


    B106880E01
  1. Disengage the 4 clips and remove the slide door window garnish.



2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B101169
  1. Using a "torx" socket wrench (T25), remove the 2 "torx" screws.



    B106881E01
  1. Disengage the 19 clips and claw, and remove the rear door trim board sub-assembly.



3. REMOVE SLIDE DOOR SERVICE HOLE NO.1 COVER


    B111436E01
  1. Disengage the clamp.

  1. Disconnect the cable from the slide door lock remote control assembly.

  1. Remove the slide door service hole No.1 cover.



4. REMOVE SLIDE DOOR CLOSER RELAY


    B102887
  1. Disconnect the connector.

  1. Remove the bolt and the slide door closer relay.