Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER

DOOR CONTROL RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR SCUFF PLATE


    B106176E01
  1. Using a screwdriver, disengage the 7 clips and 4 claws and remove the back door scuff plate.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR (Middle Roof Type)


    B113270
  1. Using a screwdriver, disengage the 21 clips and remove the quarter trim panel assembly rear LH.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR (High Roof Type)


    B113348
  1. Using a screwdriver, disengage the 35 clips and remove the quarter trim panel assembly rear LH.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE DOOR CONTROL RECEIVER
  1. Disconnect the connector.



    B102072
  1. Remove the bolt and the door control receiver.