Home › SUSPENSION & AXLE › SUSPENSION › FRONT STRUT BAR

FRONT STRUT BAR > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT STRUT BAR


    C116217E01
  1. Measure the length of the A and note it down.

    HINT:
    If using a new strut bar, set the rear side nut to the standard length.



    C102048E01
  1. Install the tube, strut bar cushion, strut bar retainer and washer to the strut bar and temporarily tighten the nut.

    NOTICE:
    Do not place the strut bar retainer and strut bar cushion in the wrong directions.



    C102011E01
  1. Install the strut bar to the front lower ball joint with the 2 bolts and 2 nuts.

    Torque:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }

  1. Temporally install the strut bar lock nut.



2. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }



3. STABILIZE SUSPENSION


4. FULLY TIGHTEN FRONT STRUT BAR


    C112994E02
  1. Tighten the nut so that the protrusion length of the thread of the front strut bar equals the length of dimension A measured before removal.



    C106504E01
  1. Using SST, fully tighten the strut bar lock nut (rear side).

    SST
    09326-22011  

    Torque:
    138 N*m{ 1,410 kgf*cm , 102 ft.*lbf }



5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)