EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR-FUEL RATIO COMPENSATION SYSTEM |
| 2. VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS |
![]() |
Check that there are no cracks, leaks or damage.
| 3. INSPECT AIR-FUEL RATIO COMPENSATION SYSTEM (Unleaded Gasoline w/ Secondary Air Injection) |
Inspect the air fuel ratio sensor.
![]() |
Connect the intelligent tester to terminals A1A+ (D1-21) and A1A- (D1-31) of the ECM.
Warm up the air fuel ratio sensor with the engine speed at 2,500 rpm for approximately 2 minutes.
Check that the voltage changes between 0 V and 1 V with the engine speed at 2,500 rpm.
Inspect the oxygen sensor.
![]() |
Connect the intelligent tester to terminals OX1B (D1-25) and E2 (D1-28) of the ECM.
Warm up the heated oxygen sensor with the engine speed at 2,500 rpm for approximately 2 minutes.
Check that the voltage changes between 0 V and 1 V with the engine speed at 2,500 rpm.
| 4. INSPECT AIR-FUEL RATIO COMPENSATION SYSTEM (Unleaded Gasoline w/o Secondary Air Injection) |
Inspect the oxygen sensor.
![]() |
Connect the intelligent tester to terminals OX1A (D1-21) and E2 (D1-28) of the ECM.
Warm up the heated oxygen sensor with the engine speed at 2,500 rpm for approximately 2 minutes.
Check that the voltage changes between 0 V and 1 V with the engine speed at 2,500 rpm.
| 5. INSPECT DUTY VACUUM SWITCHING VALVE (EVAP VSV) |
Check if the vacuum hose is connected correctly.
Disconnect the vacuum hose from the charcoal canister, and connect a vacuum gauge.
Using the flowchart below, perform an EVAP VSV operation inspection when the engine coolant temperature is 55°C (131°F) or less (while the engine is cold (VSV is closed)).
EVAP VSV operation flowchart.

Using the flowchart below, perform an EVAP VSV operation inspection when the engine coolant temperature is 80°C (176°F) or more (while the engine is hot (VSV is opened)).
EVAP VSV operation flowchart.
