EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSTALL VACUUM GAUGE |
![]() |
Using a 3-way connector, connect a vacuum gauge to the hose between the EGR valve and E-VRV.
| 2. CHECK SEATING OF EGR VALVE |
Start the engine. Check that the engine starts and then idles.
| 3. CHECK OUTPUT VACUUM WITH VACUUM GAUGE |
Connect a vacuum gauge to the output pipe.
Warm up the engine and check that the vacuum gauge reading is above 86.7 kPa (650 mmHg, 25.59 in.Hg).
If the result is not as specified, replace the vacuum pump.
| 4. CHECK HOT ENGINE CONDITION |
Visually check the vacuum hose between the vacuum pump and the EGR valve for leaks.
Warm up the engine. The coolant temperature should be between 75°C (167°F) and 90°C (194°F).
Check that the vacuum gauge reading is more than approximately 28.0 kPa (210 mmHg, 8.3 in.Hg) at idle.
Check that the vacuum gauge reading increases by more than 28.0 kPa (210 mmHg, 8.3 in.Hg) at 1,500 rpm.
When the accelerator pedal is fully depressed quickly, check that the vacuum gauge reading drops momentarily.
Keep the engine speed at more than 4,000 rpm.
Check that the vacuum gauge indicates below 3.6 kPa (28 mmHg, 1.1 in.Hg).
When the accelerator pedal is released, check that the vacuum gauge reading drops momentarily while the engine speed decreases from more than 4,000 rpm to idle.
If the result is not as specified, refer to the INSPECTION section .
| 5. REMOVE VACUUM GAUGE |
| 6. VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS |
![]() |
Check the appearance.
Check if there are any cracks, damage, or leaks on the indicted portions of the engine assembly.
| 7. CHECK VACUUM PUMP ASSEMBLY |