Home › ENGINE ยท 2TR-FE › EMISSION CONTROL › VENTILATION VALVE

VENTILATION VALVE > INSTALLATION

for Preparation Click here



1. INSTALL VENTILATION VALVE SUB-ASSEMBLY


  1. Install the ventilation valve.



      A092670
    1. Apply adhesive to 2 or 3 threads of the valve.

      Adhesive:
      Part No. 08833-00070, THREE BOND 1324 or equivalent



    2. A113530
    3. Install the ventilation valve.

      Torque:
      5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the ventilation hose to the ventilation valve.

  1. Secure the hose with the clamp.



2. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Install the engine service hole sub cover with the 5 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



3. INSTALL FRONT DOOR SCUFF PLATE RH


4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.