Home › ENGINE · 2TR-FE › EMISSION CONTROL › DUTY VACUUM SWITCHING VALVE (for EVAP)

DUTY VACUUM SWITCHING VALVE (for EVAP) > INSPECTION

for Preparation Click here



1. INSPECT VACUUM SWITCHING VALVE ASSEMBLY NO.1 (EVAP VSV)


  1. Check the resistance.



      A099531E01
    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      26 to 30Ω at 20°C (68°F)

      If the result is not as specified, replace the vacuum switching valve assembly No.1.

  1. Check the vacuum switching valve No.1 for ground.

    1. Using an ohmmeter, check the resistance between each terminal and the body.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - Body
      10 MΩ or higher
      2 - Body
      10 MΩ or higher

      If the result is not as specified, replace the vacuum switching valve assembly No.1.



  1. Check the operation.



      A099532E02
    1. Check that air does not flow from port E to port F.
      If the operation is not as specified, replace the vacuum switching valve assembly No.1.



    2. A099533E01
    3. Apply battery voltage across the terminals.

    4. Check that air flows from port E to port F.
      If the operation is not as specified, replace the vacuum switching valve assembly No.1.