Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › BLOWER UNIT

BLOWER UNIT > REMOVAL

for Preparation Click here



1. REMOVE BATTERY NEGATIVE TERMINAL

HINT:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working



2. REMOVE INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the instruction for removal of the instrument panel assembly.



3. REMOVE STEERING INTERMEDIATE SHAFT


    C102130
  1. Remove the 3 bolts and the steering shaft cover.



    C102131E01
  1. Remove the bolt.

  1. Slide the steering intermediate shaft assembly No.2 and put matchmarks on the steering gear assembly and the steering intermediate shaft assembly No.2.



4. REMOVE STEERING COLUMN ASSEMBLY
  1. Disconnect the connectors and wire harness clamps from the steering column assembly.



  1. Remove the 3 bolts and the steering column assembly.


    C106048E01



5. REMOVE AIR DUCT NO.2


    E107299E01
  1. Release the 2 claws and remove the air duct No.2.



6. REMOVE BLOWER UNIT


    E104261
  1. Remove the 2 nuts and junction block.(RHD)



    E111321
  1. Remove the nut and junction block. (body type narrow)



    E107304E03
  1. Remove the 2 clamps and 2connectors, and then disconnect the wire harness.

  1. Disconnect the 2 connectors. (w/ PTC)

  1. Remove the 3 bolts and the blower unit.



    E107714
  1. Remove the screw and wire harness. (w/ PTC)