Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › DRIVE BELT

DRIVE BELT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1


    E107311E01
  1. Belt deflection:

    Pressing force:
    98 N (10 kgf)

    New belt mm (in.)
    Used belt mm (in.)
    Belt deflection
    11 to 15
    (0.43 to 0.59)
    15 to 20
    (0.59 to 0.78)



    E109084E01
  1. Belt tension:
    Using a belt tension gauge, check the V belt tension.
    Measuring point
    New belt
    N (kgf)
    Used belt
    N (kgf)
    Belt tension
    372 to 608
    (38 to 62)
    196 to 392
    (20 to 40)

    NOTICE:
    1. Check the V belt at the specified point.
    2. When installing a new belt, adjust the belt tension within the specified range.
    3. When readjusting the belt tension, adjust the belt once again after 5 minutes of idling so that tension is within the specified range.
    4. When installing a new belt, readjust the belt tension after 5 minutes of idling so that tension is within the specified range.
    5. Check that there is clearance between the V belt and pulley.