Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR COOLING UNIT

REAR COOLING UNIT > REASSEMBLY

for Preparation Click here



1. INSTALL BLOWER MOTOR ASSEMBLY


    E104220
  1. Install the 2 blower motor assemblys with the 2 screws.

    Torque:
    0.69 N*m{ 7.0 kgf*cm , 6 in.*lbf }

  1. Install the plate washer.



2. INSTALL BLOWER (REAR) FAN SUB-ASSEMBLY


    E104219
  1. Install the 2 blower (rear) fan sub-assembly with the 2 nuts.

    Torque:
    2.9 N*m{ 30 kgf*cm , 26 in.*lbf }



3. INSTALL EVAPORATOR SUB-ASSEMBLY (REAR)


    E104218
  1. Install the evaporator sub-assembly.

  1. Install the clamp with the screw.



4. INSTALL COOLER NO.2 THERMISTOR


    E104217
  1. Install the cooler No.2 thermistor.



5. INSTALL COOLING UNIT CASE SUB-ASSEMBLY


    E104216
  1. Install the unit case sub-assembly with the 18 screws.



6. INSTALL BLOWER RESISTOR


    E104215
  1. Install the cooler blower resistor with the 2 screws.



7. INSTALL COOLER WIRING HARNESS SUB-ASSEMBLY


    E108965E02
  1. Engage the 4 clamps and 4 connectors to install the cooler wiring harness sub-assembly.