Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE ULTRASONIC SENSOR RETAINER NO.1 (w/ Clearance Sonar)
  1. Disconnect the connector.



    E075062
  1. Remove the ultrasonic sensor retainer No.1 as shown in the illustration.



2. REMOVE ULTRASONIC SENSOR NO.1 (w/ Clearance Sonar)
  1. Remove the No.1 ultrasonic sensor.



3. REMOVE ULTRASONIC SENSOR NO.2 (w/ Clearance Sonar)
  1. Remove the No.2 ultrasonic sensor.



4. REMOVE BACK STEP SUB-ASSEMBLY


    B102484
  1. Remove the 5 bolts and back step sub-assembly.



5. REMOVE REAR BUMPER BRACKET CENTER


    B102485
  1. Remove the 4 bolts and 4 rear bumper bracket centers.



6. REMOVE REAR BUMPER SIDE SUPPORT NO.2 LH


    E109049E02
  1. Remove the 2 screws.

  1. Release the 2 grommet and remove the rear bumper side support No.2 LH.



7. REMOVE REAR BUMPER SIDE SUPPORT NO.2 RH


8. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    E103122E01
  1. Remove the 2 screws.

  1. Pull in the direction indicated by the arrow, disengage the 2 pins and separate the rear combination light assembly.

  1. Disconnect the connector and remove the rear combination light assembly.



9. REMOVE REAR COMBINATION LIGHT ASSEMBLY RH


10. REMOVE REAR BUMPER COVER UPPER LH


    B103052E02
  1. Remove the screw.

  1. Release the clip and 3 claws and remove the rear bumper cover upper.



11. REMOVE REAR BUMPER COVER UPPER RH