ROOF HEADLINING (for Semi-trim) > REMOVAL |
| 1. DISCONNECT BATTERY NEGATIVE CABLE |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Remove the 5 clips and front door scuff plate LH.
| 3. REMOVE FRONT DOOR SCUFF PLATE RH |
| 4. REMOVE FRONT DOOR OPENING TRIM LH |
| 5. REMOVE FRONT DOOR OPENING TRIM RH |
| 6. REMOVE SLIDE DOOR WEATHERSTRIP NO.1 RH |
| 7. REMOVE FRONT ASSIST GRIP NO.1 PLUG |
![]() |
Using a screwdriver, disengage the assist grip plug No.1.
| 8. REMOVE ASSIST GRIP ASSEMBLY |
![]() |
Remove the 2 screws and assist grip.
| 9. REMOVE FRONT PILLAR GARNISH LH (w/o Rear Cooler) |
![]() |
Remove the 2 clips.
Using a screwdriver, disengage the 3 clips and remove the front pillar garnish LH.
| 10. REMOVE FRONT PILLAR GARNISH RH (w/o Rear Cooler) |
| 11. REMOVE FRONT PILLAR GARNISH LH (w/ Rear Cooler) |
![]() |
Using a screwdriver, disengage the clip and claw and remove the front pillar garnish LH.
| 12. REMOVE FRONT PILLAR GARNISH RH (w/ Rear Cooler) |
| 13. REMOVE ASSIST GRIP |
![]() |
Using a screwdriver, disengage the assist grip plugs.
![]() |
Remove the 2 screws and assist grip.
| 14. REMOVE VISOR HOLDER |
![]() |
Remove the screw.
Using a moulding remover, disengage the claw and remove the visor holder.
| 15. REMOVE VISOR ASSEMBLY LH |
![]() |
Remove the 2 screws and visor assembly LH.
| 16. REMOVE VISOR ASSEMBLY RH |
| 17. REMOVE ROOM LIGHT NO.1 ASSEMBLY |
![]() |
Using a screwdriver, disengage the 4 claws and remove the light cover.
![]() |
Remove the 2 screws.
Disconnect the connector and remove the room light No.1 assembly.
| 18. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (w/ Rear Cooler) |
![]() |
Remove the bolt and disconnect front seat outer belt assembly RH.
![]() |
Using a screwdriver, disengage the 2 claws and cover.
![]() |
Remove the bolt and disconnect front seat outer belt assembly RH.
| 19. REMOVE SEPARATOR BAR BRACKET LOWER (w/ Rear Cooler) |
![]() |
Remove the screw and separator bar bracket lower.
| 20. REMOVE CENTER PILLAR GARNISH LOWER RH (w/ Rear Cooler) |
![]() |
Remove the clip.
Using a screwdriver, disengage the 4 clamps and remove the center pillar garnish lower RH.
| 21. REMOVE CENTER PILLAR GARNISH COVER LOWER LH (w/ Rear Cooler) |
![]() |
Using a screwdriver, disengage the 4 claws and remove the center pillar garnish cover lower LH.
| 22. REMOVE SEAT ASSEMBLY LH (w/ Rear Cooler) |
Disconnect connector.
![]() |
Remove the nut and 3 bolts.
Remove the seat assembly LH.
| 23. REMOVE SEAT BELT ANCHOR COVER (w/ Rear Cooler) |
![]() |
Remove the 2 clips.
Disengage the claw and then remove the seat belt anchor cover.
| 24. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (w/ Rear Cooler) |
![]() |
Remove the bolt and disconnect the front seat outer belt assembly LH.
![]() |
Using a screwdriver, disengage the 2 claws and cover.
![]() |
Remove the bolt and disconnect the front seat outer belt assembly LH.
| 25. REMOVE CENTER PILLAR GARNISH LOWER LH (w/ Rear Cooler) |
![]() |
Using a screwdriver, disengage the 4 clips and remove the center pillar garnish lower LH.
| 26. REMOVE CENTER PILLAR GARNISH RH (w/ Rear Cooler) |
![]() |
Remove the clip.
Using a screwdriver, disengage the 2 clamps and claw, and remove the center pillar garnish RH.
| 27. REMOVE ENGINE SERVICE HOLE COVER HOOK NO.2 LH |
![]() |
Remove the screw and the engine service hole cover hook No.2 LH.
| 28. REMOVE CENTER PILLAR GARNISH LH (w/ Rear Cooler) |
![]() |
Using a screwdriver, disengage the 3 clips and claw, and remove the center pillar garnish LH.
| 29. REMOVE ROOM LIGHT ASSEMBLY NO.2 |
![]() |
Using a screwdriver, disengage the 4 claws and remove the room light assembly No.2.
![]() |
Remove the 2 screws.
Disconnect the connector and remove the room light assembly No.2.
| 30. INSTALL ROOF HEADLINING MOULDING (Narrow Type) |
Release the 7 clips and remove the roof headlining moulding.

| 31. REMOVE ROOF HEADLINING MOULDING (Wide Type) |
Release the 9 clips and remove the roof headlining moulding.

| 32. REMOVE ROOF CLIP |
![]() |
Using a screwdriver, disengage the 2 claws and remove the roof clip.
| 33. REMOVE ROOF HEADLINING NO.4 |
Release each clip and remove the roof headlining No.4.

| 34. REMOVE ROOF HEADLINING NO.3 |
Release each clip and remove the roof headlining No.3.

| 35. REMOVE ROOF HEADLINING NO.2 |
Release each clip and remove the roof headlining No.2.

| 36. REMOVE REAR COOLER CONTROL PANEL (w/ Rear Cooler) |
![]() |
Release the 4 clips and 4 claws, and disconnect the rear cooler control panel.
Disconnect the connector and remove the rear cooler control panel.
| 37. REMOVE ROOF HEADLINING NO.1 |
w/ Rear Cooler:
Remove the 4 screws.
Release each clip and remove the roof headlining No.1.
