WINDOW DEFOGGER WIRE > REPAIR |
| 1. INSPECT WINDOW DEFOGGER WIRE |
![]() |
Check the continuity, as the center of each defogger wire, as shown in the illustration.
| 2. REPAIR WINDOW DEFOGGER WIRE |
![]() |
Clean the broken wire tips with a grease, wax and silicone remover.
Place the masking tape along both sides of the wire to be repaired.
Thoroughly mix the repair agent (Dupont paste No.4817).
![]() |
Using a fine tip brush, apply a small amount of the mixture to the wire.
After a few minutes, remove the masking the tape.
Do not repair the defogger wire for at least 24 hours afterwards.