Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/o Secondary Air Injection System)

SFI SYSTEM (w/o Secondary Air Injection System) > Starter Signal Circuit

for Preparation Click here


DESCRIPTION

While the engine is being cranked, the positive battery voltage is applied to terminal STA of the ECM.

WIRING DIAGRAM


A111670E02


INSPECTION PROCEDURE

The following troubleshooting flowchart is based on the premise that the engine is cranked normally. If the engine will not crank, proceed to the problem symptoms table. (Click here)
1.READ VALUE OF INTELLIGENT TESTER (STA SIGNAL)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / Starter Sig.

  1. Check the value displayed on the tester when the ignition switch is turned to the ON and START positions.

    OK:

    Ignition Switch Positions
    ON
    START
    Starter Sig
    OFF
    ON



OK
GO TO PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (ECM - ST RELAY)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STARTER RELAY


NG
REPLACE STARTER RELAY
OK

REPLACE ECM