Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/o Secondary Air Injection System)

SFI SYSTEM (w/o Secondary Air Injection System) > ECM Back-up Power Source Circuit

for Preparation Click here


DESCRIPTION

The battery supplies electricity to the ECM even when the ignition switch is OFF. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared.

WIRING DIAGRAM


A111669E01


INSPECTION PROCEDURE

1.CHECK EFI FUSE


    A102921E01
  1. Remove the EFI fuse from the engine room R/B No.1.

  1. Measure the resistance.

    Resistance:
    Below 1 Ω

  1. Reinstall the EFI fuse.



NG
REPLACE EFI FUSE
OK


2.INSPECT ECM (BATT VOLTAGE)


    A065741E07
  1. Measure the voltage between the terminals of the ECM connectors.

    Voltage:
    Tester Connections
    Specified Conditions
    BATT (B9-3) - E1 (D1-3)
    9 to 14 V



NG
Go to step 3
OK

REPLACE ECM 

3.CHECK HARNESS AND CONNECTOR (ECM - EFI FUSE, EFI FUSE - BATTERY)


    A111148E01
  1. Check the harness and the connector between the EFI fuse and ECM.

    1. Remove the EFI fuse from the engine room R/B No.1.

    2. Disconnect the B9 ECM connector.

    3. Measure the resistance.

      Resistance (Check for open):
      Tester Connections
      Specified Conditions
      EFI fuse (2) - BATT (B9-3)
      Below 1 Ω

      Resistance (Check for short):
      Tester Connections
      Specified Conditions
      EFI fuse (2) or BATT (B9-3) - Body ground
      10 kΩ or higher

    4. Reconnect the ECM connector.

    5. Reinstall the EFI fuse.

  1. Check the harness and the connector between the EFI fuse and battery.

    1. Remove the EFI fuse from the engine room R/B.

    2. Disconnect the positive battery terminal.

    3. Measure the resistance.

      Resistance (Check for open):
      Tester Connections
      Specified Conditions
      Battery positive cable - EFI fuse (1)
      Below 1 Ω

      Resistance (Check for short):
      Tester Connections
      Specified Conditions
      Battery positive cable or EFI fuse (1)
      - Body ground
      10 kΩ or higher

    4. Reconnect the positive battery cable.

    5. Reinstall the EFI fuse.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT BATTERY
  1. Check that the battery is not depleted.



NG
REPLACE BATTERY
OK

CHECK AND REPLACE ENGINE ROOM RELAY BLOCK